Well my JBA plug wires are getting fried and are arcing out. So I ordered some NGK plugs and Taylor 10.4mm wires.
I was also thinking of getting the boot protectors. But now I'm thinking of just wrapping the headers. That would also keep the bay temp down. Kinda like a two for one deal.
Anyone have any input?

Sounds like a smashing idea.

I don't think it's a smashing idea :(

If your engine bay never gets wet you're OK. But with header wrap I wouldn't want the water collecting on my headers if driven in weather or through a car wash.

I don't think it's a smashing idea :(

If your engine bay never gets wet you're OK. But with header wrap I wouldn't want the water collecting on my headers if driven in weather or through a car wash.


I was thinking of using DEI header wrap kit. Along with their HT silicone coating to seal them.
After looking at the shorties. And what I would have to go through. I thought "screw that" The coating on the headers is good enough. LOL...